E/ECE/324

Add.1/Rev.4/Amend.5

E/ECE/TRANS/505

4 December 2001

AGREEMENT

CONCERNING THE ADOPTION OF UNIFORM TECHNICAL PRESCRIPTIONS

FOR WHEELED VEHICLES, EQUIPMENT AND PARTS WHICH CAN BE FITTED AND/OR

BE USED ON WHEELED VEHICLES AND THE CONDITIONS FOR RECIPROCAL RECOGNITION

OF APPROVALS GRANTED ON THE BASIS OF THESE PRESCRIPTIONS */

(Revision 2, including the amendments which entered into force on 16 October 1995)

__________

Addendum 1: Regulation No. 1

Revision 4 - Amendment 5

02 series of amendments **/ - Date of entry into force: 8 September 2001

UNIFORM PROVISIONS CONCERNING THE APPROVAL OF MOTOR VEHICLE HEADLAMPS EMITTING AN ASYMMETRICAL PASSING BEAM AND/OR A DRIVING BEAM AND EQUIPPED WITH FILAMENT LAMPS OF CATEGORIES R2 AND/OR HS1

__________

UNITED NATIONS

Insert new paragraphs 14. to 14.7., to read:

"14.	TRANSITIONAL PROVISIONS

14.1.	As from six months after the official date of entry into force of Regulation No. 112, Contracting Parties applying this Regulation shall cease to grant ECE approvals according to this Regulation.

14.2.	Contracting Parties applying this Regulation shall not refuse to grant extensions of approval to this and any previous series of amendments of this Regulation.

14.3.	Approvals granted under this Regulation before the date of entry into force of Regulation No. 112 and all extensions of approvals, including those to a preceding series of amendments to this Regulation granted subsequently, shall remain valid indefinitely.

14.4.	Contracting Parties applying this Regulation shall continue to issue approvals for headlamps on the basis of this and any previous series of amendments to this Regulation, provided that the headlamps are intended as replacements for fitting to vehicles in use.

14.5.	As from the official date of entry into force of Regulation No. 112, no Contracting Party applying this Regulation shall prohibit the fitting on a new vehicle type of a headlamp approved under Regulation No. 112.

14.6.	Contracting Parties applying this Regulation shall continue to allow fitting on a vehicle type or vehicle of a headlamp approved to this Regulation.

14.7.	Contracting Parties applying this Regulation shall continue to allow fitting or use on a vehicle in use of a headlamp approved to this Regulation as amended by any previous series of amendments, provided that the headlamp is intended for replacement."

___________